UNFABRICATED / UNFINISHED, as produced SLABS offer customers with in-house fabrication or cutting capability the opportunity to purchase large 62" x 98" slabs at significantly reduced prices and quicker shipment schedules versus factory fabricated laptops. The use of lower cost local facilities to fabricate slabs will allow maximization of the full sheet of material with any off-fall or cut pieces utilized for back/side splash curbing, window sills, pegboards, reagent shelving, student desks, etc.
Durcon Epoxy Slabs must be cut with Diamond tipped circular saw blades, drill bits, routers, or water jet systems, etc., due to the density and hardness of the laboratory top material. Care must be taken with the feed speed and the RPM (revolutions per minute) of the circular saw blades so as not to damage the material. Water cooling of the saw blades is highly recommended.
Conventional carbide tipped or wood working tools used to cut Corian or other solid surfacing or alternative paper based products, should not be considered when cutting epoxy countertops.
Unfabricated / Unfinished slab sizes are:
Metric Slab Sizing
1590 x 2490 mm nominal
62" x 98"
1855 x 2490 mm nominal
Minimum order quantities of full pallets will apply. 7 slabs of 1" and 9 slabs of 3/4" offered only to qualified fabricators (QF) with stone cutting or dedicated equipment to fabricate Epoxy tops, with water cooled systems. Slabs are supplied oversized for trimming at your local facility to the finished size required, with MINIMUM waste.